Broncolor Minicom 160, Руководство по эксплуатации

Страница: 10 / 25

11
Attention: The operating voltage of the modelling lamp must correspond to the mains
voltage.
4.a kSopoStionalit|
The brightness of the modelling light can be set proportionally to the flash intensity. To
assure proportionality also when units with different power output ratings are operated
together, the units have various proportionality levels. Proportionality is guaranteed if the
identical prop level has been set for all units. The higher the digit, the brighter the
modelling light.
The following operating modes are possible:
"P" This level can be set if either only Minicom 40 or only Minicom 80 or Minicom 160
are in use (most intense proportional modelling light). That means, the modelling
light is proportional to the energy level 300 J, 600 J or 1200 J.
"P1" Proportional modelling light with broncolor power packs rated 6400 J
"P2" Proportional modelling light with broncolor power packs rated 3200 J
"P3" Proportional modelling light with broncolor power packs rated 1600 J
"P4" This proportionality level is optimised for an output level of 800 J. Recommended
modelling light when using Minicom 80 in combination with Minicom 40.
Recommended modelling light when using the Minicom 160 in combination with
Minicom 80.
"P5" If a unit is operated at a lower output level, the modelling light will be relatively
weak and yellowish. To counteract this problem, the Minicom monolights are
equipped with the additional modelling light proportionality level "P5". It is
optimised for the output level 400 J and less. Thus the brightness of the
modelling light can be increased.
"HI" The unit operates at full modelling light, independent of flash output
"LO" The unit operates at lower lighting level, independent of flash output, to reduce
power consumption and extend the service life of the halogen lamps
Pressing the "mod" key (5) for 1 second when the modelling light is on, will give direct
access to the "HI" mode. To return to the previous mode briefly press the "mod" key.
4.^ Replacing the halogen lamps
Attention: Before replacing the halogen lamp, it is essential to discharge the unit by
flashes, immediately afterwards, disconnect it from the power supplyž
Before exchanging the modelling lamp let the monolight discharge and cool
down for 10 min.ž For your safety, only original flash tubes must be usedž
The halogen lamps are plug-in.
The protecting glasses have a marking line and the glass rim has 2 grooves. When
removing the protecting glass from the unit the marking line must be situated at the top.
First the protecting glass has to be pulled off carefully in an axial direction (avoid tilting).