Bron D 1600, Руководство по эксплуатации

Страница: 7 / 15

8
2. FITTING OR CHANGING A BULB
Before fitting or changing a bulb, the lamp must be disconnected from the ballast unit. Then
remove the reflector or adapter.
Fitting: Turn the focusing wheel (11) on the lamp to its stop in the “flood” (bare bulb) position. The
bulb socket is now extended as far as it will go. Open the two cover plates (15) and push the bulb
into the socket to the stop. Afterwards, take care that the cover plates are completely closed again.
Removing: Caution: the bulb is hot! Allow the bulb to cool before changing it!
Turn the focusing wheel (11) on the lamp to its stop in the “flood” position. The bulb socket is now
extended as far as it will go. The bulb can now be pulled out. The two cover plates (15) are spring-
loaded and can be opened.
3. MOUNTING AND REMOVING REFLECTORS AND ADAPTERS
Mounting: Undo the retaining screw (10) on the lamp. Align the mounting pin on the reflector
with the appropriate opening (20), then position the accessory and turn it 10° clockwise until
you hear the security pin (16) latch. Take care not to damage the bulb while dismounting an
accessory!
Removing: Loosen the retaining screw (10) on the lamp, then pull it straight backwards and
hold it. Turn the reflector through 10° until it is released. Remove the reflector or adapter
straight forwards. Take care not to damage the bulb while dismounting an accessory!
Attention: When operating with an adapter for a Para or Softbox, the focusing wheel (11) must
be turned to the “flood” (bare bulb) position (bulb as far forwards as it will go) so that the safety
switch is actuated and the bulb can be fired.
For operation with Softboxes an adapter, Art. No. 744-0310 is available as an accessory.
4. FITTING AND REMOVING ACCESSORIES
Unlatch the movable jaw (28) by pushing it against the spring and fold it outwards. The four-
leaf barn doors (27, 34) and, where fitted, a scrim ring (26) can now be introduced from above
into the outer mounting grooves of the fixed claws (30). If a further accessory, such as
a filter
or diffusion lens (25, 33) is required, it can be fitted in the inner mounting grooves. Fold the
moving jaw (28) down so that it latches. Turn the four-leaf barn door to make sure it is securely
mounted.