18
bromic.com/heat
HEATER INSTALLATION INSTRUCTIONS - PORTABLE
CONTINUED...
27. Within the Base, remove 4 X Oval Head
screws (#4-40 - Length: 3/8”) from the Small
Connector Box, and remove lid.
28. Attach the male connector on the Heater
Head cable to the female connector inside the
small connector box.
26. Using a spirit level and phillips head
screwdriver, adjust the angle of the heater
head to be level by adjusting the 4 x Dome
Head screws (M4 - Length: 6mm) on the heater
head.
NOTE:
If heater head can not be made level by
adjusting 4 screws, check mounting floor
provides a level surface to support the heater
on.
All 4 x Dome Head screws must be
tightened completely once heater head is
level to the ground, to prevent head from
moving.
The base MUST NOT be plugged into
power source when attaching the connector.
DANGER
4x
#4-40 - Length: 3/8”
(Preassembled)
4x
M4 - Length: 6mm
(Preassembled)
IMPORTANT
!
Heater must be level when in use to prevent
damage to heater head components. Heater
must be operated on a level surface.
WARNING
!
