1300 276 642
bromicrefrigeration.com.au
10
6. PRODUCT LOADING AND STORAGE
Start-up
• Clean the interior surface with a soft cloth and warm water before loading.
• Ensure there is free circulation of air between the products.
• Do not block the evaporator fan.
• Do not overstock the refrigerator.
• Keep refrigerator door openings to a minimum.
• Some products are sensitive to ultraviolet (UV) light, please see storage guidelines from
the manufacturer before removing from packaging.
• Maximum recommended shelf load (for each shelf) is specified in section 3 (page 5) of
this manual. Do not overstock.
NOTE: Bromic cannot be responsible for loss of stock or damage to stock.
IMPORTANT
: Run the refrigerator for at least 2 hours before loading.
7. MAINTENANCE
WARNING
: Disconnect the appliance from the power supply before performing any
maintenance. Never unplug the appliance by pulling on the cord. Always grasp the
plug firmly and pull straight out of the outlet.
WARNING
: Exposure to significant water ingress will void warranty and cause
potential safety issues. If the unit should be exposed to water, please contact the
manufacturer immediately.
IMPORTANT: Warranty may be void if there is no evidence of preventative
maintenance is performed on the appliance.
WARNING
: WARNING: Do not store explosive substances such as aerosol cans with
a flammable propellant inside the appliance.
Condenser Coil/Filter
IMPORTANT:
The filter and the condenser coil must be cleaned once a month with
vaccum/brush to maintain the performance and minimise power consumption. The
filter (for selective models) can be removed for cleaning with water, make sure it is
dried before reattaching. A poorly maintained condenser coil can lead to failure of the
unit and higher cabinet temperatures.
The condenser is located at the top of the cabinet next to the compressor, use
caution while cleaning as fins are sharp.
