Assembly Instructions
Before mounting your product, confirm there will be no interference with the towing vehicle, ground, tongue, or any
other accessories while stationary or in motion. Check for sufficient clearance to avoid interference in all positions
including handle rotation, handle swing and swivel positions if applicable. Check for sufficient clearance after
installation is completed.
Bolt-On Mounting Bracket Instructions
If using a bolt on jack, assure the correct mounting hole
pattern for your tongue size. The gap between the tongue
and the mounting bolts is not to exceed .06 inches.
1) Place the jack against the tongue and position the
mounting brackets/straps on the opposite side of the
tongue as illustrated. Align the holes in the straps with
the holes in the bracket.
2) Insert four bolts through the bracket and the straps.
The top two bolts can rest on the tongue. The bottom
bolts should be less than .07 inches below the tongue.
3) Secure the bolts with locknuts. Torque nuts to 25 ft
LBS
4) Check to ensure clearance of handle, coupler and
trailer jack handle. Reposition if needed.
Snap Ring/Bolt Through Instructions:
To attach a snap ring style jack:
- Place the jack over the mount and place the snap ring in the
groove. Ensure the snap ring is seated completely and firmly
in the snap ring groove.
To attach a bolt through jack:
- Place the jack bracket into the recessed opening in the
mount. Place a small end of a bushing into the bracket on
the jack and on to the bolt. Tighten locknut until there is
little movement of the bushing.
- Note: Bolt should not be installed between the trailer
tongue and the mount. The jack’s bracket will be held by
the bushing between the mount and the locknut.
2
