B101784-4-0712
Page 6
Caution: Be careful when handling parts, as they may
contain sharp edges. Work gloves are recommended to prevent
injury. Remove protective plastic covering.
To hard mount the cart to a deck, start at Step 1. If not installing
directly to a deck, skip to Step 3.
1. Place the Base Assembly on the work surface with casters
facing up. Remove the four screws securing each caster and
retain for possible future use. Repeat this step for the remaining
three casters. See Figure 1.
Figure 1
2. Determine the location for the grill. Ensure proper
clearances to combustibles as recommended in the grill
head manual. Use three drywall or deck screws of at least
2-1/2 inches in length to fasten Base Assembly to deck. The
screws will protrude 3/4 inch into the deck. See Figure 2.
Note: It is always recommended to use longer screws to secure
the cart base when possible.
Figure 2
3. Attach Left Panel to Rear Panel with two 1/4-20 x 3/4 screws,
two lock washers and two nuts. Do not tighten. See Figure 3.
4. Attach Right Panel to Rear Panel with two 1/4-20 x 3/4 screws
and two nuts. Do not tighten. See Figure 3.
Note: Once Left, Right and Rear Panels are assembled, they be-
come the “Cart Assembly.”
C
Art
A
SSEmbly
Figure 3
5. Place Cart Assembly onto Base Assembly and secure with
six 1/4-20 x 3/4 screws and six lock washers (two per panel).
Do not tighten screws until all screws and lock washers are
properly inserted into the base. See Figure 4.
Figure 4
6. After tightening the Base Assembly screws, tighten the nuts
and screws from Steps 3 and 4.
