B102521-0-0219
Page 31
Check for Gas Leaks
Check for gas leaks every time you connect your Broilmaster
propane gas grill to a Propane gas cylinder, when a connected
cylinder has not been used recently, or when either a natural or
propane grill is being used for the first time.
WARNING
D
o not use an open flame to check for leaks. Checking for
leaks with an open flame may lead to a fire or explosion,
resulting in property damage or personal injury.
To check for gas leaks:
1. Use water dish and a little dish washing liquid to make a
soapy solution.
2. Turn OFF the knob on the control panel.
3. Turn ON the gas at the supply or cylinder. A hissing sound
indicates a leak. Turn OFF the gas and repair the leak.
4. Apply the soapy water solution to all gas connections.
5. Look for bubbles. Bubbles indicate a leak.
6. If you see bubbles turn OFF the gas and repair the leak.
7. Turn the gas back ON and repeat the above procedures until
all leaks are repaired.
Air Shutter Adjustment
The venturi air shutter(s) are preset at the factory so that after
five minutes the burner flames are blue with well defined cones.
If, after five minutes the flame is yellow, or there is a gap between
the burner and the flame, adjust the venturi air shutter as follows:
1. Turn gas OFF and let the burner cool.
2. Loosen shutter set screw.
3. Close the air shutter to the minimum opening.
4. Light the burner, wait five minutes and then carefully open
the air shutter until the flame is blue and well-defined.
5. Retighten the set screw.
Heat Indicator Recalibration
The heat indicator can be recalibrated if needed. Remove the heat
indicator from the grill and place the probe end in a pot of boiling
water. Set the heat indicator by turning the screw in the end of
the stem until it reads 212 degrees. The indicator is now set.
LIGHTING WITH A MATCH
OPERATION - PROPANE AND NATURAL GAS GRILLS
Operating Instructions
Lighting with the Electric Ignitor
CAUTION
I
f a burner fails to light after 5 seconds, turn the burner
OFF for 5 minutes, to allow the gas to clear, then try again.
1. Open the grill lid.
2. Turn burner knob CLOCKWISE to the OFF position.
3. Turn ON the gas at the source.
4. With the grill lid open, push and turn the burner control knob
COUNTERCLOCKWISE to Hi.
5. Push and hold the ignitor button until the burner lights
(approximately 5 seconds).
6. If a burner does not light, turn OFF all gas and refer to the
Troubleshooting section of this manual.
Lighting with a Match
CAUTION
I
f a burner fails to light after 5 seconds, turn the burner
OFF for 5 minutes, to allow the gas to clear, then try again.
1. Open the grill lid.
2. Turn the burner knob CLOCKWISE to the OFF position.
3. Turn ON gas at the source.
4. With the grill lid open, push and turn the burner control knob
COUNTERCLOCKWISE to HI.
5. Insert a long wooden lighted match through the lighter hole
on either side of the grill.
See Figure Below.
6. If a burner does not light, turn OFF all gas and refer to the
Troubleshooting section of this manual.
