EG300 Broilchef LP Gas Grill
Owner’s Manual
16
To prevent fire or explosion hazard when testing for a leak:
1. Always perform the “leak test“ before lighting the grill and each time the cylinder is connected for use.
2. Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3. Conduct the leak test outdoors in a well-ventilated area.
4. Do not use matches, lighters or a flame to check for leaks.
5. Do not use grill until all leaks have been stopped. If you are unable to stop a leak, disconnect the propane supply, call for gas
appliance service or your local propane gas supplier.
Checking for Leaks
1. Make 2-3 oz. of leak solution by mixing one part liquid dishwashing soap with three parts water.
2. Make sure control knobs are in the “OFF” position.
3. Spray some solution on the tank valve up to the regulator connection. (See diagram to right.)
4. Inspect the solution at the connections for bubbles. If no bubbles appear, the connection is secure.
5. If bubbles appear, you have a leak. Go to step 6.
6. Disconnect the regulator from the tank and reconnect. Make sure the connection is tight and secured.
7. Retest with solution.
8. If you continue to see bubbles, replace the cylinder.
Lighting Your Grill
DANGER:
Failure to open lid while igniting the grill’s burners or not waiting five minutes to allow gas to clear if the grill does not light, may
result in an explosion, which could cause serious bodily injury or death.
WARNING:
Never stand with your head directly over the grill when preparing to light the main burners, to prevent possible bodily injury.
Lighting Main Burner
1. Open
lid during lighting.
WARNING:
Attempting to light the burner with the lid closed may cause an
explosion. Make sure there are no obstructions of airflow to the gas unit. Spiders and
insects can nest and clog the burner/venturi tube at the orifice. A clogged burner tube
can lead to a fire beneath the appliance.
2. Make sure all control knobs are in OFF position.
3. Turn on gas source or tank valve.
4. Ignite only the burner you wish to use. Push and turn the knob to “HIGH” then press
the igniter button 2 or 3 seconds immediately. The burner should light.
5. If ignition does NOT occur, turn the knob to OFF, wait 5 minutes and repeat
the lighting procedure.
6. To ignite another burner, push and turn the knob to “HIGH”. If ignition does NOT occur in
5 seconds, turn the burner to OFF, wait 5 minutes and repeat the lighting procedure.
Adjust valve knob(s) to desired cooking temperature.
Using the Lighting Stick to Light the Main Burners
1. Insert a match into the end of lighting stick. Light the match.
2. Once lit, put the lighting stick through the cooking grid and place the flame next to
the burner ports found along the sides of the desired burner (See diagram to right.)
3. Press the valve knob and rotate it counterclockwise to the ‘’HIGH’’
position. The burner should light immediately. If more than one burner
is desired, repeat the procedure 2-3 until all desired burners are lit.
4. Adjust
valve
knob(s)
to
the desired cooking temperature.
Precautions:
1. After lighting, observe the burner flame. Make sure all burner ports are lit.
2. If the burner flame goes out during operation, immediately turn the gas “OFF”. Open lid
to let the gas clear for at least 5 minutes before re-lighting.
3. Before cooking on the grill for the first time and operate the grill for approximately 15 minutes with the lid closed and the
gas turned on “HIGH”. This will “heat clean” the internal parts, dissipate odor from the manufacturing process and painted
finish.
Push
