GPT1813G
Instruction Manual
Guide d’utilisation
7
Step 2
a) Insert the venturi side of the burner (G) through the hole on
the right side of body.
b) Align the pre-drilled hole under the burner with the hole on
the bottom of body.
c) Insert one flat washer (HH
)
,
one lock washer (GG)
and one
bolt (FF) into the pre-drilled hole.
d) Tighten the bolt using the screwdriver provided.
e) Screw the regulator valve (H) into the threaded venturi tube
of the burner.
Step 4
a) Align the holes on the lower right front side and lower
right back side of the body assembly with the holes on
the right leg (N).
b) Insert one bolt (BB) into each pre-drilled hole and
tighten
it with one flat washer (DD), one lock washer
(CC) and one nut (EE).
c) Repeat the procedure for the left leg (M).
d) Go back and tighten all the bolts using the screwdriver
provided.
Insert the ignition cable into the electrode
underneath the firebox.
Step 3
a) Align the holes on the left side of the firebox with
the holes on the heat plate support (I).
b) Insert the bolts on left handle (J) into each
pre-drilled hole and tighten with
one flat washer
(HH), one lock washer (GG), and one nut (II) in
sequence.
c) Repeat the procedure for the right handle (K)
and another heat plate support (I) with the right
side of the firebox.
d) Go back and tighten all the nuts using the
wrench provided.
e) Insert the ignition cable into the electrode
underneath the firebox. (See the figure on
the right).
