GSF2818KS/GSF2818KS-2
Instruction Manual
Guide d’utilisation
11
Step 12 (Side burner assembly)
a) Open the side burner lid and place the side burner
assembly (Q) onto the right side shelf. Make certain
the venturi tube is connected properly with valve.
b) Align the four holes on the side burner assembly
(Q) with the four holes on the right side shelf. Insert
one bolt (DD) with one lock washer (GG) and one
flat washer (FF) into each hole, tighten all bolts by
hand.
c) Connect the side burner ignition wire by sliding it
onto the electrode on the side burner assembly (Q).
(See diagram to the right).
d) Go back and tighten all bolts using the screwdriver
provided.
e) Place the side burner support (P) on the side
burner assembly (Q), then close the side burner lid.
Step 10 (Assemble the side shelves to the body assembly)
a) Loosen the three pre-installed bolts on the right side of body assembly and leave 1/4 of the bolt's length extendin
g
from body
assembly.
b) Align the holes on the right side shelf (R) with the bolts extended from the right side of body assembly. Push down the right side
shelf until it locks into place.
c) Align the holes on right side shelf with the holes on the control panel and body assembly.
d) Insert one bolt (AA) with one lock washer (CC) and one flat washer (BB) into each pre-drilled holes. (See above diagram).
Tighten bolts by hand until secure.
e) Repeat the procedure for the assembly of left side shelf (C) and body assembly.
Step 11 (Side knob and seat assembly)
a) Align the holes on the side knob seat (S) with the holes on
the right side shelf and the side burner valve. Screw one bolt
(EE) with one flat washer (FF) into each pre-drilled hole by
hand.
b) Tighten the bolts using the screwdriver provided.
c) Insert the side knob (T) onto the valve shaft.
Insert
