RTU32R Installation and Wiring Guide
Brodersen A/S, Islevdalvej 187, DK-2610 Roedovre, Denmark , Tel: +45 45 35 26 27, Fax: +45 45 35 26 29, Email: [email protected]
14
7.
Safety and Precautions
Environmental
Always ensure adequate ventilation is provided for the equipment and do not obstruct ventilation holes.
The temperature and humidity ranges shown in the specifications for this product must not be exceeded.
This equipment must not be installed in an area that is subject to a corrosive atmosphere, excessive moisture or may allow water or
other liquids to come into contact with the unit or its external connections.
In the close proximity of some radio frequency transmitters, the signal to noise ratio of this product may be reduced. If this occurs, re-
location of the equipment or the signal cables is recommended.
ESD
This product contains static-sensitive devices. Observe ESD precautions when working on the equipment with the cover removed.
Electrical Safety
When powered by a Mains Power supply the product contains wiring that is energised to 230 V RMS AC mains.
Always ensure that the equipment is correctly earthed by connection to an AC mains supply with a protective earthing
connection.
Ensure power supply cabling is adequately rated for the unit’s operating current and protected, in case of short circuit, by
a correctly rated fuse or circuit breaker.
Always replace blown fuses with the correct type and rating.
Unpacking and Handling
The equipment should be unpacked and inspected immediately on receipt. If damage has occurred please advise your carrier or
supplier.
This equipment contains electronic devices that are sensitive to electrostatic discharge. Please take precautions to avoid
damage to the electronics by static electricity.
It is advisable to retain the original equipment packing in the event that the equipment ever needs returning
for service.
Ensure that the name and address of the Authorised Distributor from whom you purchased the unit is recorded for future reference.
Packing for Return for Repair
All electronics assemblies must be properly packed in ESD protective packing for transport, to prevent physical
and ESD damage.
The filler material used for packing for return for repair must be antistatic or static dissipative, as this may come into
contact with exposed connectors, wiring, or PCB assemblies. The use of nonconductive filler material may cause damage
to the electronic assemblies reducing their operational life, or even destroying them.
Advice on packing the product for return can be provided by Brodersen.
Document: 40296 120 RTU32R Installation and wiring guide_2012_05_23.docx
