Brocade Communications Systems VDX 8770-8, Справочник по аппаратуре, Страница: 39 / 40

Brocade VDX 8770-8 Hardware Reference Manual 21
53-1002564-01
Establishing a serial connection to the Brocade VDX 8770-8
3
To establish a serial connection to the serial (console) port on the Brocade VDX 8770-8, complete
the following steps.
1. Verify that the Brocade VDX 8770-8 is powered on and that POST is complete by verifying that
all power LED indicators on the management, switch fabric, and line card modules display a
steady green light.
2. Remove the shipping cap from the serial port (labeled II0I0I) on the active management
module.
By default, the management module installed in slot MM1 is the active management module
unless an error occurs. The active management module is also indicated by an illuminated
green LED labeled A
ACTIVE.
3. Use the serial cable provided with the Brocade VDX 8770-8 to connect the serial port on the
active management module to a computer workstation.
If the serial port on the workstation or terminal device is DB9 instead of RJ-45, remove the
adapter on the end of the serial cable and insert the exposed DB9 connector into the DB9
serial port on the workstation.
ATTENTION
The serial port is intended primarily for the initial setting of the IP address and for service
purposes.
4. Disable any serial communication programs running on the workstation (such as
synchronization programs).
5. Open a terminal emulator application (such as HyperTerminal on a PC, or TERM, TIP, or Kermit
in a UNIX environment), and configure the application as follows:
•
In a Windows environment:
•
In a UNIX environment, enter the following string at the prompt:
tip /dev/ttyb -9600
If ttyb is already in use, use ttya instead and enter the following string at the prompt:
tip /dev/ttya -9600
Parameter Value
Bits per second 9600
Data bits 8
Parity None
Stop bits 1
Flow control None