FIPS Security Seal Procedures for Brocade FCX Series and Brocade FastIron SX Series
11 of 13
Publication Number: 53-1002119-01
Applying seals to Brocade FastIron SX 1600 devices
Use the figures in this section as a guide for security seal placement on a Brocade FastIron SX 1600 device.
The connectors on the faceplates of a particular module might vary from the connectors shown on the figures, but
the placement of the seals will be the same. There is no seal placement required on the top panel, bottom panel, or
side panels of Brocade FastIron SX 1600 devices. Each Brocade FastIron SX 1600 device requires the placement of
24 seals:
•
Front: Affix 21 total seals to the front panel of the device. Affix one horizontally-oriented seal to the upper ear of
each module installed in the top row of the chassis as shown in
Figure 7
on page 12. As much as possible of the
seal should be affixed to the module to the right of the screw that secures each module to the chassis. Affix one
horizontally-oriented seal to the lower ear of each module installed in the bottom row of the chassis as shown in
Figure 7
. As much as possible of the seal should be affixed to the module to the left of the screw that secures
each module to the chassis. Affix one seal from the upper left corner of the fan tray to the chassis, as shown in
Figure 7
. All 21 of the seals should lie flat against the front panel of the device.
