MODELS EWT1306SS • EWT1366SS
Page 3
INSTALL THE DUCTWORK
(Ducted Hoods Only)
1. Decide where
the ductwork
will run
between the
hood and the
outside.
2. A straight, short
duct run will
allow the hood
to perform most
efficiently.
3. Long duct
runs, elbows
and transitions
will reduce the
performance of
the hood. Use as few of them as possible. Larger ducting
may be required for best performance with longer duct runs.
4. Install wall cap or roof cap. Connect round metal ductwork
to cap and work back towards the hood location. Use duct
tape to seal the joints between ductwork sections.
MEASURE THE INSTALLATION
The minimum hood distance above cooktop MUST NOT BE
LESS than 26”.
A maximum of 36” above cooktop is highly recommended for
best capture of cooking impurities.
Distances over 36” are at the installer and user's discretion;
providing that the ceiling height permits.
6"
ROUND DUCT
ROOF CAP
ROUND
ELBOW
26" MIN. ABOVE
COOKING SURFACE
WALL
CAP
HOOD
DECORATIVE
FLUE
HH0302A
10-1/2”
WALL CAP
26” - 36” ABOVE
COOKING SURFACE
HOOD
DECORATIVE FLUE
ROOF CAP
6” ROUND DUCT
ROUND ELBOW
11-7/8”
TO CENTER OF
BRACKET HOLES
HOOD
MOUNTING
BRACKET
3-3/8”
DUCT
CENTER
LINE
HH0303A
PREPARE THE HOOD
Unpack hood and check contents. You should receive:
1 - Hood
1 - Decorative Flue Assembly
2 - Damper Flaps
1 - Lower Flue Mounting Bracket
1 - Upper Flue Mounting Bracket
1 - Hood Mounting Bracket
2 - Aluminum Grease Filters (
EWT1 series
, included
packaged in a cardboard box)
2 - Hybrid Baffle Filters (
EWT1 series
, included packaged in a
cardboard box)
1 - Installation Manual
1 - Parts Bag containing:
4 - Mounting Screws (no. 8 x 3/8” Pan Head)
9 - Mounting Screws (no. 8 x 1-1/2” Flat Head)
9 - Drywall Anchors
2 - Washers
7 MOUNTING
SCREWS
(no. 8 x 1½”
Flat Head)
7 DRYWALL
ANCHORS
4 MOUNTING
SCREWS
(no. 8 x 3/8”
Pan Head)
DECORATIVE FLUE
2 WASHERS
UPPER
FLUE MOUNTING
BRACKET
HOOD
MOUNTING
BRACKET
LOWER
FLUE MOUNTING
BRACKET
DAMPER
FLAPS
HR0258A
11½’’
9
9
