INST
ALLA
TION,
USE & CARE INSTR
UCTIONS
INST
ALLA
TION
10
PREPARE THE UNIT
a
ll
inStallationS
1 . If present, remove all protective polyfilm from the unit and/
or parts .
2 . Remove the grease filter(s) by pushing down on latch tab
and tilting the filter(s) downward (FIG . 14) . Set aside the
filter(s) .
3 . Disassemble the electrical compartment cover (grey part
in FIG . 15) from inside the unit by removing its retaining
screw . Remove the parts bag behind the cover . Set aside
the parts bag and the cover along with its screw .
HD1356
FIG. 14
HD1357
SCREW
FIG. 15
HD1359
FIG. 17
SCREWS
TAB
HD1358
FIG. 16
4 . Punch out
one
of the two knock-out holes . Install an
appropriate 7/8” diameter strain relief (not included, grey
part in FIG . 16) .
NOTE: The HCK44 cord connection kit (optional) can
be used instead of the house power cable . Refer to the
instruction packed with the HCK44 cord connection kit .
H
orizontal
exHauSt
inStallation
only
5 . Unplug the blower cable from its connector on faceplate .
Disassemble the faceplate from the unit by removing its
4 retaining screws (two per side) and disengaging its
retaining tab (one per side) from the unit shell (FIG . 17) .
Set aside the faceplate along with its screws .
6 . Remove the 4 screws (two per side) retaining the blower
support plate to the top of the unit (FIG . 18) . Carefully lift
out and set aside the blower with its support plate . The
blower will be reinstalled later in the unit .
HD1360
FIG. 18
SCREWS
SCREWS
