Made in the USA by Broadsight Systems, Inc. for Hanwha Techwin
Page 1 of 2
INSTALLATION MANUAL – Door Jamb Camera with 2MP Pinhole Network Camera
Unpacking
Unpack carefully. This is mechanical equipment and should
be handled with care. If an item appears to have been
damaged in shipment, replace it properly in its carton and
notify the shipper. If any items are missing, notify the
vendor. The shipping carton is the safest container in which
the unit may be transported. Save it for possible future use.
Service
If the unit ever needs repair service, the customer should
contact the vendor for a return materials authorization (RMA)
and shipping instructions.
Care and Maintenance
Perform routine maintenance to keep the unit dust free.
Model Designation
SKK-CJ601/US
Door Jamb Camera with Hanwha SNB-
6010N 2MP Pinhole Network Camera
Description
This unit is designed to be installed at eye-level at the exit of
an establishment. The Door Jamb Camera captures a facial
shot of a perpetrator as he or she leaves the establishment.
Hardware Kit
2 x Cable Ties
2 x Cable Tie Mounts
2 x Plastic Wall Anchors
2 x #8 Cross Recessed self-tapping screw
Tools Required
#2 Cross Recessed Screwdriver (Phillips)
Level
Drill with 3/16” Bit (Optional 1/8” Bit)
Optional: De-burr Tool
Certification
Installation should be performed by a licensed professional
and conform to the National Electrical Code (NEC) and any
applicable local codes.
Installation
1.
Choose desired location for camera installation. Verify
mounting structure and surface is capable of supporting
the camera and no obstacle or interference is present
from existing installed devices or wiring.
2.
Remove Door Jamb Camera cover by removing black
Phillips head screw at the top of the unit. Remove cap
and set both aside. Lift cover up and out to remove from
back rail.
3.
Use back rail as a template to mark mounting hole
locations. Use level to ensure unit is vertical before
marking surface.
4.
If using plastic anchors, drill a 3/16” hole at the
mounting screw locations. If the anchors are not being
used, drill a 1/8” hole in mounting surface. If routing
cable through wall, drill appropriate sized hole to
accommodate network cable and RJ45 connector (skip to
Step 6).
5.
If routing camera cable through top knockout, pull cable
back through camera base and re-route to top knockout.
Feed cable through top cap; it will hang loosely until final
step. Route cable to network box and plug in.
6.
If routing cable through wall, feed camera cable through
central hole in installation surface; route as needed to
network box installation location. Plug cable into
network box.
7.
Position back rail over mounting hold locations and
secure to wall with #8 screws from the hardware kit.
8.
Adjust camera field of view by loosen thumb wheel above
camera bracket and rotating camera assembly to desired
position.
9.
Place cover over base frame about 3/4” inch above
bottom of frame. With light pressure, push toward base
and down until cover is seated against bottom of frame
and cover is secure.
10.
Place top cover plate in position and tighten screw with
light pressure. Do not over torque.
11.
Refer to Quick Installation Guide for instructions on
camera setup and installation of network box.
Remove top screw
to access camera
Loosen thumbwheel to
adjust field of view
