Introduction: Broadcom BCM943
30UARTSDB
Wireless Communication
Device
User's Gu
i
de
Before you begin
Things you should know
Before you begin
Obtain the following information from your network administrator (if you are a home user, obtain this information from the person that
installed your wireless access point):
●
Network names (SSID) of the specific wireless networks that you want to connect to.
●
WEP (Wired Equivalent Privacy) key information (if any) for the networks you want to connect to.
●
For Microsoft® Windows® networking, your customer name and workgroup name.
●
For your network account, your user name and password.
●
Your IP address (if not using a DHCP server)
Things you should know
When you start your computer, your Broadcom
BCM94330UARTSDB
card detects certain wireless networks that are
within range. Before you can connect to these and other wireless networks, you must configure a profile for each network using the
information you obtained from your network administrator.
WEP is a security protocol for wireless local area networks (defined in the IEEE 802.11
g
standard) that encrypts data sent over radio
waves. The use of the WEP key is optional and can be enabled or disabled. If the network you are connecting to has enabled WEP, you
must also enable WEP in the network profile and set the WEP key to match the WEP key used by the network. Otherwise, you cannot
connect to the network.
Broadcom
BCM94330UARTSDB
network
The Broadcom
BCM94330UARTSDB
solution allows you to make a wireless connection to a network, as illustrated below.
