e-mail:
voice:
360.854.9559
fax:
866.783.1742
14
NTP Server Sentinel
®
Installation and Operation Manual
OPERATION
“Device Setup” Web Page
Email Addresses:
Email messages can be sent when GPS lock is acquiring,
disconnected, or valid lock. Up to eight email address
assigned to using the checkboxes labeled 1-8.
Log GPS State Change: This enables the email logging of GPS lock status. See the
“Email/Network setup” page for email and logging settings.
Enable GPS Alarm:
TC Enabled:
Enables or disables serial time code output.
TC Format:
Allows you to set time code output to desired format. Either
TC89 or TC90.
TC Frequency:
Sets serial time code operating frequency.
Relay Closure:
This is used to control the units DPDT relay (TS-K1, TS-
K2) for external time sync applications. Up to four closures
per hour can be configured. Each closure can be pro-
grammed for any minute and any second of each hour.
Closures are configured at 12:00, 22:00, 42:00, and 58:30
by default. The closure duration can be between 100ms and
900ms in 100ms increments, the default is 500ms.
NOTE:
After any item has been
changed, you MUST
press the “Save
Settings” button for
your changes to be
saved.