Broadcast Tools, Inc.
DSC-20, Dual Satellite Receiver Controller Set-up guide
Installation and Operation Manual
Broadcast Tools, Inc.
Page 11
INSTALLATION Continued
(SG) StarGuide II table configuration setup
The StarGuide II and/or III receiver selection table may be modified to meet
your needs. Each of the 20 memory locations per receiver port may be changed. To
change any of the locations for Receiver port one and/or two, follow the steps below.
Step 1.
Connect one end of the supplied modular cable to J5 (Computer) on the
DSC-20 and the other end to the male D-Sub to modular adapter
labeled “S-9”.
Step 2.
Plug the female D-Sub modular “S-9” adapter into your computers serial
port.
Step 3.
Press the space bar ONCE and the configuration menu will appear.
Step 4.
Enter number 5 to modify the StarGuide II and/or III table data for Recvr
port # 1 or 6 to modify Recvr port # 2.
Step 5.
Enter the location you desire to change.
Step 7.
Refer to the StarGuide II and/or III’s receiver manual and your Network
provider for the required parameters to enter in step 8.
Step 8.
Enter up to 48 characters and terminate by a carriage return. To enter a
carriage return in the string, enter a back slash [ \ ] and press the enter key
twice. Example: *1E00\enter key, enter key. The carriage return takes the
form of [13] when viewed on screen.
Step 9.
Press <Q> to return to the MAIN MENU.
Step 10.
Press <Q> to QUIT.
Tool Tip:
More than two receivers may be controlled by the DSC-20. By
purchasing the SDD-8, Serial data (router) director, up to 32
additional receivers may be control from one receiver port of the
DSC-20.
