e-mail:
voice:
360.854.9559
fax:
866.783.1742
23
Audio Sentinel
®
+ Streaming Installation and Operation Manual
SETUP
“Email/Network Setup” Web Page – SNMP Manager Settings
SNMP Enable Traps:
When enabled trap messages will be sent. When
unchecked, no trap messages will be sent.
SNMP Manager IP Address:
This is the IP address of the SNMP manager. The system
will send traps to this IP address only.
SNMP Manager Trap Port:
This is the port number that SNMP trap messages will be
sent.
Default port 162.
SNMP Read Community:
This is the community name for Read-Only access.
SNMP Write Community:
This is the community name for Read-Write access.
NOTE: A cold-start trap will be sent when the unit boots up if the SNMP Enable Traps
is checked, otherwise trap messages are sent when a device enters or exits an alarm
condition, depending on whether or not alarms are enabled.
“Email/Network Setup” Web Page – NTP Settings
NTP Enabled:
Must be enabled to sync.
Default: Enabled
NTP (Time) Server Address:
Enter the NTP address here.
Default: pool.ntp.org
NTP Port:
Normally 123.
Default: 123
NTP Update Interval (Min):
Interval between timing updates.
Default: 30
“Email/Network Setup” Web Page – Other Settings
Site ID:
This is the Site Identifier that is display on the web and in
each email.
Monitor Refresh Time (Sec):
Interval at which the Monitor & Control page refreshes.
Default: 1 sec.
Time Zone Offset from UTC:
Sets the time zone offset from GMT.
Default: -8 hours
Set Time:
The hour, minute, second, month, day and year boxes can
be used to set the time of the RTC. The time is only updat-
ed if you click “Save Time” and not when you “Save
Settings”.
Enable Event Logging:
Enabling these checkboxes will generate an alarm, but will
not send an email. If the system is configured for Daily
Alarm emails, then that Daily Alarm email will contain the
Event Logging items as well.
Login:
Whenever someone logs into the system, the username and
date/time will be logged.
Email:
Whenever an email is sent, the type of email and date/time
will be logged.
Reboot:
Whenever the device boots, the date/time will be logged.
WEBSITE:
Visit our web site for
product updates and
additional information.
