8-Port DC Power Manager User Manual (PS-8DC-5V/12V/24V/48V)
9
RS-232 AND TELNET COMMANDS
COMMAND
DESCRIPTION AND PARAMETERS
HELP
SHOW THE FULL COMMAND LIST.
?
SHOW THE FULL COMMAND LIST.
HELP N1
SHOW A DESCRIPTION OF COMMAND N1.
N1 = {COMMAND NAME} (UPPERCASE ONLY)
IPCONFIG
DISPLAY THE CURRENT IP CONFIGURATION.
IPSTATIC N1 N2 N3
SET THE FULL STATIC IP CONFIGURATION.
N1 = X.X.X.X [X = 0 ~ 255, IP ADDRESS]
N2 = X.X.X.X [X = 0 ~ 255, NETMASK]
N3 = X.X.X.X [X = 0 ~ 255, GATEWAY]
IPDHCP N1
ENABLE OR DISABLE DHCP FOR OBTAINING THE UNIT’S IP
CONFIGURATION.
N1 = ON, OFF
VERSION
SHOW THE UNIT’S FIRMWARE VERSION.
FADEFAULT
RESET THE UNIT TO THE FACTORY DEFAULT SETTINGS.
REBOOT
REBOOT THE UNIT.
PWN N1 N2
ENABLE OR DISABLE POWER OUTPUT N1.
N1 = 1 ~ 8 [PORT NUMBER]
N2 = ON, OFF
PWR N1 NAME N2
RENAME POWER OUTPUT N1.
N1= 1~8 [PORT NUMBER]
PWR_STATUS N1
SHOW THE CURRENT POWER STATE (VOLTS, WATTS, AMPS)
N1 = 1 ~ 8 [PORT NUMBER]
N2 = {NAME STRING} [16 CHARACTERS MAX]
TEMPERATURE
SHOW DETAILS OF THE UNIT’S TEMPERATURE
AND FAN CONTROL SETTINGS.
FAN SET N1
SET NON-“AUTO MODE” FAN SPEED OR ENABLE “FAN AUTO MODE”.
AVAILABLE VALUES FOR N1:
0 ~ 100 [DISABLE FAN AUTO MODE AND SET THE
FAN SPEED TO THE SELECTED PERCENTAGE]
AUTO [ENABLE FAN AUTO MODE]
FAN_SET N1 N2 N3
SET THE FAN SPEED AND TEMPERATURE THRESHOLD FOR THE SELECTED
AUTOMATIC SPEED TIER.
AUTO_LOW [AUTO FAN SETTING TO ADJUST]
AUTO_MID
AUTO_HIGH
N2 = 0 ~ 100 [TEMPERATURE THRESHOLD IN °C]
N3 = 0 ~ 100 [FAN SPEED IN PERCENT]
Note:
Commands will not be executed unless followed by a carriage return <CR>. In
addition commands are not case-sensitive unless specified.
