LBO-H/DP-EAD-T User Manual
Link Bridge
TM
Fiber Optic HDMI/DisplayPort Transmitter
Broadata Technical Support, [email protected]
7
2.0 SETUP
The BCI LBO Optcial Extender Series units are used in pairs. One
LBO-H/DP-EAD-T transmitter unit is located at the near-end (source)
and connected through a single fiber optic cable, to one of the LBO
receivers like the LBO-HDMI-R receiver shown below and located at
the far-end (sink) of the link. Figure 2-1 depicts a typical installation for
the LBO-H/DP-T-EAD and LBO-HDMI-R.
Figure 2-1
LBO-H/DP-T with LBO-HDMI-R
2.1 Mounting
Before installing the units into your housing, make sure there is
enough space to pull and connect both the electrical and optical
cables without stressing them beyond the manufacturer’s
limitations (also known as the minimum bend radius).
2.2 Cabling and Connectors
In order to setup the LBO-H/DP-EAD-T properly, make sure to
observe the following instructions when installing the proper
cables. The LBO-H/DP-EAD-T requires two parts to the cabling
setup, the electrical and the optical.
