LBC-H-R-DOP User Manual
Link Bridge
TM
HDBaseT HDMI Receiver w/Dual Video Output
Broadata Technical Support, [email protected]
7
2.2 Rear Panel
1.
POWER LED:
Once the power supply is connected the LED
will illuminate.
2.
DC 24V:
Plug the 24V DC power supply into the unit and connect
the adaptor to an AC outlet.
3.
IR 2 BLASTER:
Connect to the supplied IR Blaster cable for IR
signal transmission. Place the IR Blaster in direct line-of-sight of
the equipment to be controlled.
4.
IR 1 EXTENDER:
Connect to the supplied IR Extender cable
for IR signal reception. Ensure that remote controller being used
is within the direct line-of- sight of the IR Extender.
5.
USB:
This port is reserved for firmware update only.
6.
LINK LED:
The link LED will illuminate when both the input source
and output display signals are connected through CAT cable.
When it blinks regularly it states the display is NOT sending
signals to Receiver but the Transmitter and Receiver are linked
and if it blink irregularly it states an error has occurred.
7.
CAT-5e/6/7 IN:
Connect this port to HDMI to CAT-5e/6/7
Transmitter (with or without PoC function) with CAT-5e/6/7 cable
to extend the signal up to 100m.
POWER
DC 24V
CAT5e/6/7 IN
IR 2
BLASTER
USB
LINK
IR 1
EXTENDER
1
2
3
4
5
6
7
