Brivo ACS Installation Manual
ACS5000-E
ENG-WI-001 © 2005 Brivo Systems, LLC. All rights reserved.
Page 25
2. Wire the DOOR LOCK RELAY terminal block.
a) Connect the door latch to the COM terminal and either the NO or NC terminal.
b) The DOOR LOCK RELAY provides both NO (Normally Open) and NC (Normally
Closed) contacts, and is driven in response to the presentation of valid
credentials or the programmable REX input.
c) Timing and other aspects of relay activation are programmed through ACS
Online.
d) The relay is rated at 3A at 125VAC.
3. If used, wire the DOOR LOCK 250MA terminal block.
WARNING: AEN Port
THIS TERMINAL BLOCK IS A VOLTAGE SOURCE; DO NOT APPLY EXTERNAL
BATTERY.
a) The DOOR LOCK 250MA terminal block may be used to directly drive a door
latch that operates at no more than12V and uses 250 mA or less.
b) Directly wire the door latch in a manner that observes the polarity requirements
of the device.
c) This output is driven by the same logic that drives the standard door lock relay,
described above.
4. If used for an alarm shunt, wire the AUX RELAY terminal block.
a) The AUX RELAY terminal block can be used for a variety of purposes, such as
alarm shunting, and is programmed via ACS Online.
b) The fully programmable AUX RELAY provides both NO (Normally Open) and
NC (Normally Closed) contacts.
c) The relay is rated at 3A @ 125VAC.
5. If used, wire the AUX INPUTS terminal block.
a) The IN1 and IN2 terminals are contact closure type inputs that share a COM
terminal.
b) The terminals can be used for a variety of purposes, and are programmed
through ACS Online.
6. If used, wire the AUX OUTPUTS 250MA terminal block.
a) The OUT1 and OUT2 outputs provide up to 25mA of current at +12V to power
external relays or other devices.
b) The outputs are programmed via ACS Online.
c) Wire the Reader switches to the last block of terminals in this door node.
NOTE: Refer to the Wiring Guide for Brivo approved devices and connection
diagrams.
