Brivo ACS Installation Manual
ACS5000-E
ENG-WI-001 © 2005 Brivo Systems, LLC. All rights reserved.
Page 12
Assembly Procedures
Assemble and mount chassis.
1. Install the supplied nylon stand-offs into each chassis by inserting them from the rear.
NOTE: This step MUST be performed before the chassis is mounted to the wall.
Once the chassis has been mounted, it is not possible to insert the stand-offs.
a) There are five stand-offs for each board, but there are more holes than that in the
chassis.
b) Determine which holes you will use based on the size of the boards you are
installing.
2. Mount
the
chassis.
a) Use four bolts to mount each chassis securely in place.
b) Make sure the chassis door can swing open freely to allow for access after the
installation is complete.
3. Remove any knock-outs that may be required to accommodate conduit or wiring.
WARNING: Knockouts
DO NOT ATTEMPT TO REMOVE THE KNOCKOUTS WITH A HAMMER. Banging
on the knockouts may result in shock to the circuit boards, which could cause
permanent damage. Pry them out using a screwdriver.
4. Assemble the chassis.
a) Install the power supply board in each chassis first. If you install the MAIN
BOARD or a Door or INPUT OUTPUT BOARD first, you may find it difficult to
position your screwdriver in a way that will allow you to install the power supply
board later.
b) Install the MAIN BOARD in the control chassis.
•
Install each board by aligning it with the previously installed stand-offs
and then gently pressing it into place. You will hear a slight click as the
board settles into the locked position on the standoffs
c) If there is a DOOR BOARD or an INPUT OUTPUT BOARD for the control
chassis, install that now, using the procedures described for the MAIN BOARD.
d) If there are expansion chassis, install the appropriate DOOR BOARDs and/or
INPUT OUTPUT BOARDs in each chassis at this time, using the procedures
described for the MAIN BOARD.
e) You will note that the control panel kit contained an adhesive Identity Label. This
label should be affixed to the inside of the front door of the control chassis,
beneath the large wiring guide.
5. Install the tamper switch in each chassis.
