CLEANING YOUR FIRE
Turn the fire off and allow it to cool before attempting any cleaning.
Normally the fire will only need dusting. The bright metal trims may be cleaned with a
damp cloth and dried with a soft duster. Obstinate marks can be removed from the guard
and trims using soapy water.
Never use abrasive cleaners.
The radiants can be cleaned with a soft brush - see the following section for removing
the radiants.
REPLACING THE RADIANTS
See figure 4.
Always use the correct type
of replacement radiant. Ask
for part number 5110472
Turn the fire off and allow it
to cool before attempting to
remove the radiants
.
Remove the dress guard by
pressing down the two hooks
at the top. Tilt the guard
forward and lift out.
Lift the radiant upward to clear
the metal retaining bar then
pull out bottom first.
Fit the new radiant by inserting
its top under the top lip of the
radiant box then swing the
bottom of the radiant over and
behind the retaining bar.
It is important that the front face of the radiant should rest
against the front of the retaining channel.
Replace the dress guard. Locate the bottom
of the dress guard in the two holes in the bottom panel apron. Push the guard back so
that the two spring projections at the top of the guard engage in the slots under the front
decorative canopy.
Page 8
OWNER GUIDE
Figure 4.
