!
When the pilot has lit keep the control knob depressed for about ten seconds to
allow the flame sensing probe to warm up.
!
The control control knob can then be set to your preferred heat level. The settings
are: -
To turn off
partially depress the knob and
turn clockwise to off.
Wait at least three
minutes before attempting to relight.
Lighting with a match or taper
Depress the control knob slightly and turn
anticlockwise towards the 1/IGN position.
While keeping the knob depressed, light the
pilot by inserting a long match or taper into
the opening as in figure 3.
When the pilot is alight, keep the knob
depressed for about ten seconds to allow the
flame sensing probe to warm up before setting
to your preferred heat level.
For your own convenience, have the heater
serviced as soon as possible.
Page 7
OWNER GUIDE
Control Knob
Position
Radiants Condition
2
Centre radiants on low. Outer radiants off.
(The right hand centre radiant will glow slightly
more than than the left hand centre radiant due
to the pilot flame)
3
Centre radiants fully on. Outer radiants off.
4
Centre radiants fully on. Outer radiants on low.
5
All radiants fully on.
Figure 3.
