Briteq STAGE BEAMER RGB, Руководство пользователя

Страница: 8 / 22

2.3 SETTING UP WITH A DMX512 CONTROLLER
2.3-1 DMX512 ADDRESSING WITHOUT ID ADDRESSING
( TOUR MODE)
The figure above shows a simple DMX512
layout with the starting address of the first
unit set at 1, with the second set at 11and
so on... (Note that when used in this way,
the Ch10 ID function must be inactive (CH10=0))
Connect the DMX512 controller to the units in series.
Each unit has 10 DMX channels so the DMX Addresses should increase by
increments of 10 (e.g. 1,11,21,31...)
The ID address has not been set so therefore when using the controller CH
10 must be inactive ( CH10=0 ).
It is also possible to deactivate ID address selecting ID OFF from the
Settings menu. on the fixture
Each DMX Address may be used as many times as required.
Any DMX address in the range from 001 to 512 may be used.
2.3-2 DMX512 ADDRESSING WITH ID ADDRESS
(TOUR MODE)
Connect the DMX512 controller to the units in series
Each unit has 10 DMX channels so the DMX Addresses should increase by
increments of 10 (e.g. 1,11,21,31...)
Each DMX Address may be used as many times as required.
Any DMX address in the range from 001 to 512 may be used.
Each DMX address may carry up to 66 separate ID addresses.
ID should be set in the menu on each unit in ascending values
(i.e. 1,2,3...)
ID On should be set in the Settings menu on each unit.
ID addresses are accessible from Ch10 on the DMX512 controller.
Example:
6 2 INSTALLATION 2009.11.10