ENGLISH
OPERATION MANUAL
BRITEQ
®
9/23
BTX-TITAN
MENU
You can use the buttons or touch screen to navigate the setup menu with its different sub menus etc. You
can easily change settings like DMX address, different functions etc.
Use the UP / DOWN buttons to navigate the menu and change the values of the selected functions.
Each time you select a menu item or change a setting you must press the ENTER button to confirm.
Press the MENU button to return to the (previous) menu.
TOUCHSCREEN
– MAIN INTERFACE LAYOUT:
When the unit is switched on, the display shows the BriteQ logo, followed by the main interface as shown
below. The main interface is splitup in different parts (icons). You can press these icons, which are in fact
shortcuts, to immediately access different parts of the setup menu (see drawing).
FIXTURE ID
The Fixture id (ranging from 0001 to 9999) makes installation easier because each product can be identified
by a unique number. With the internal battery, no need to plug the power to set or read the fixture id.
To change the fixture id a password is needed: the password is
“1702”.
LAMP CONTROL
Set the lamp ON or OFF
CHANNEL MODE
Set the channel mode of BriteQ BTX-TITAN:
Mode 1:
24 Channels
Mode 2:
25 Channels
Mode 3:
16 Channels
DMX INPUT
is green:
received DMX-signal is OK.
is red and lcd is blinking:
received DMX-signal is NOT OK or NO DMX-signal received.
Used to set the desired input for the DMX signal:
Wired Input:
XLR (3 or 5pin) input is used.
Wireless Input:
DMX-signal comes from an external wireless transmitter (sold separately)
Wireless Input / XLR out:
DMX-signal comes from an external wireless transmitter (sold separately). The
wireless DMX-signal is also available at the DMX output port (3 or 5 pins) for further daisy chaining of
other equipment.
Important Remark:
originally this projector is NOT equipped with a wireless receiver module. A wireless
receiver module is optionally available.