Briteq BTX 5R BEAM, Руководство по эксплуатации

Страница: 6 / 100

ENGLISH OPERATION MANUAL
BRITEQ
®
4/95 BTX-BEAM 5R
LAMP (RE)PLACEMENT
In case of replacement of the lamp or maintenance, do not open the fixture within 10
minutes until the unit cools down after switching off. Always unplug the unit before
servicing! Always use the same type of spare parts (bulbs, fuses, etc.) When replacing
parts, please only genuine spare parts.

Switch off the unit and unplug the mains cable.

Wait for about 10 minutes until the unit has been cooled down.

Use a screwdriver to unscrew the screws to open the cover of the fixture.(Fig. 1)

Remove the fan (Fig. 2)

Inside you will see the lamp socket. Remove the lamp socket gently out of the lamp compartment.

Pull out the cable (Fig.3)

Replace the cable to the new lamp, insert the lamp gently (Fig. 4)

Adjust the hotspot using a screw (Fig. 4)
Attention! Check the label on the backside of the device or see the technical specifications in this manual
to know which lamp should be used. Never install lamps with a higher wattage! Lamps with higher wattage
generate temperatures the device was not designed for. If the device uses a lamp transformer, it will burn
due to current overload.

Don’t touch the bulb with bare hands! This drastically shortens the lifespan of the lamp. If you touched the
lamp, clean it with a cloth and a little denatured alcohol. Wipe the lamp off before installing.

Be sure that the wires don’t touch the lamp.

Reinstall the fan

Close the cover

Done
Fig.1 Use 1/4 Turn to loosen the
four screws and open the cover.
Fig.2 Use 1/4 Turn to loosen the screws and take out
the fan.
Fig.3 Take away the old lamp.
Fig.4 Unplug all the connect wires over the lamp and
(wear anti-static gloves) take on the lamp. Put the
new lamp in place.