ENGLISH
USER MANUAL
BRITEQ
®
6/7
BT-STROBE 1500
Operation via optional CA-8 remote:
•
Connect the CA-8 remote to the 6,3mm jack connector (4) on
the BT-Strobe 1500 (5)
•
Connect the BT-Strobe 1500 to the mains
•
Set DIP-switch 1 to ON
•
Now you can use the CA-8 remote to control the strobe.
o
[STAND BY] button (1) : used to switch ON and
OFF the light output.
o
[FUNCTION] button (2) : single flash when pushed
once shortly, continuous flashing when pushed
continuously.
o
[MODE] button (3) : There are 3 modes available.
LED OFF : the BT-Strobe 1500 will show
it’s patterns audio triggered
LED BLINKING : press the [FUNCTION]
button briefly to change the flashing
speed. Push the [FUNCTION] button
longer to change the dimming mode.
LED ON : press the [FUNCTION] button to
choose the next pattern which will be
running audio triggered.
MAINTENANCE
•
Make sure the area below the installation place is free from unwanted persons during servicing.
•
Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
•
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
•
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
•
When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
•
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
•
In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
•
The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
•
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit’s optics.
•
Clean with a soft cloth using normal glass cleaning products.
•
Always dry the parts carefully.
•
Clean the external optics at least once every 30 days.
•
Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
