ENGLISH
USER MANUAL
BRITEQ
®
7/9
BT-AKKUBAR
•
Press the
▲ or ▼ buttons until the display shows
[UErn]
.
•
Press the [
ENTER
] button. The display shows the version
[U1.0]
.
•
Press the [MENU] button to leave.
SETUP FOR WIRELESS OPERATION
Each unit has a wireless DMX receiver on board.
To set up the system, you first need to assign each receiver to the universe (transmitter) it should work with.
VERY IMPORTANT THINGS TO KNOW BEFORE USE
Before you start using these wireless DMX units, you should know about the following some basic
information. It will save you a lot of time and frustration:
•
Check information on the [ID] button (10) and status led (17).
o
Status LED (17) WHITE (RGB lit) : unit is disconnected from any transmitter (unpaired).
o
Status LED (17) GREEN : unit is connected to a transmitter (paired).
o
Status LED (17) GREEN (blinking slow) : unit is paired but receives no DMX-signal from transmitter.
o
Status LED (17) RED (blinking) : the transmitter is OFF.
•
A receiver can only be paired with a transmitter while it is completely disconnected (unpaired): status led
(17) is WHITE (RGB leds on the display are lit).
SETTING UP WIRELESS DMX MODE
•
Press the [ID] button (10). The status LED will become WHITE (RGB leds lit), RED (blinking) or GREEN
(the last selected mode).
•
If the status led (17) is WHITE (RGB leds lit), press the ID button on your transmitter. The GREEN led on
the BT-AKKUBAR will start blinking during pairing and will stay lit when the pairing has succeeded.
•
If the status led (17) is GREEN, the BT-AKKUBAR is already paired with a transmitter. To unpair it from the
transmitter, press the [ID] button (10) for about 5s until the status led (17) turns WHITE (RGB leds lit).
•
If the status LED (17) is RED, the BT-AKKUBAR is already paired with a transmitter but it doesn
’t receive a
signal (transmitter is OFF).
•
The status LED will turn white and after a few seconds turns RED (fast blinking if there is no signal present)
or GREEN (when the receiver is paired with a transmitter).
•
The unit is now in receiver mode.
•
Release the receiver from any universe (transmitter) by pressing the [ID] button (10) for about 5 seconds.
The status led (17) now turns WHITE (RGB leds lit). The unit is now ready to be paired with a transmitter.
PAIRING TRANSMITTER AND RECEIVER(S)
•
First of all : prepare the receiver(s) as described above.
•
Pairing with one or more receivers always has to be performed on the transmitter!
•
Press the [ID] button on your transmitter. The BLUE led starts blinking and the led on the receiver(s) starts
blinking GREEN at the same time.
After a few seconds the leds stop blinking. The transmitter and receiver(s) are now paired.
DISCONNECTING RECEIVERS FROM A DMX UNIVERSE (TRANSMITTER)
To disconnect all the receivers from a DMX universe / transmitter:
•
Press the [ID] button from your transmitter for about 5 seconds until the status LED (17) on the receiver(s)
turn(s) WHITE (RGB leds lit).
•
After a few moments the status LED on the transmitter turns BLUE again.
•
You can also re-connect the receiver(s) again simply by pressing shortly on the [ID] button on the
transmitter. The status LED (17) on the receiver(s) turn(s) GREEN again.
To disconnect an individual receiver from a DMX universe / transmitter:
•
Press the [ID] button (10) of the receiver for about 5s until the status LED (17) becomes WHITE (RGB lit).
•
This receiver is now disconnected from the transmitter (DMX universe).
