ENGLISH
USER MANUAL
BRITEQ
®
8/9
BT-AKKUBAR
OPERATING INSTRUCTIONS
A. Standalone 1unit:
•
Press the [MENU] button.
•
Press the
▲ or ▼ button until
[dIn]
is shown on the display.
•
Press the [
ENTER
] button to select. The display shows the actual value (between
000 and 100)
•
Use
▲ and ▼ buttons to change the value.
•
Once the desired value is shown on the display, press the [
ENTER
] button to
confirm.
B. Controlled by IR-4 remote-controller:
•
Press the [MENU] button.
•
Press the ▲ or ▼ buttons until the display shows
[Ir]
.
•
Press the [
ENTER
] button. The display shows
[on]
or
[oFF]
.
•
Press the ▲ or ▼ buttons to change to
[on]
or
[oFF]
.
•
Press the [
ENTER
] button. The IR remote control function is now turned on
[on]
or off
[oFF]
.
IR-4 REMOTE
1. [OFF]-button:
used to switch off the output of the projector.
2. [UP]-button:
this button is used to increase the light output of the projector.
3. [DOWN]-button:
this button is used to decrease the light output of the projector.
4. [ON]-button:
used to switch on the output of the projector.
5. Battery compartment:
receives a CR2025 3V-battery (supplied).
C. Controlled by a wireless DMX-controller:
ATTENTION : the wireless DMX controller must be compatible with Wireless Solutions Sweden!
•
Turn on the wireless DMX controller. (for example : JB Systems EZ-CON 24W )
•
Turn on all the units and give each unit a DMX address. When each unit has its own unique DMX-
address, you can control them individually.
DMX CHART
Mode 1CH:
DMX
Channel
DMX-value
function
remarks
1
000-255
Master Dimmer 0% - 100%
MAINTENANCE
•
Switch off the unit and unplug the mains cable.
During inspection the following points should be checked:
•
When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
•
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
•
In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
•
BATTERY maintenance:
We strongly advice to follow the maintenance requirements imposed by the
battery reseller. On top of that you should at least every 6 months:
•
Do a visual check of the battery: cleanness, terminal damage, any damage of the
housing, …
•
Check if the poles of the battery are still well tightened to the wires.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
RECYCLING OF USED BATTERIES:
used Li/ion batteries should be considered and handled as
dangerous waste. Each country has its own regulations for the recycling of used rechargeable
