14
Rethreading the harness
To refit the cover, place it on the seat and
pull the buckle and adjuster strap through
the correct slots in the cover. Put the
comfort pad on over the buckle.
Pull the harness straps and chest pads through
the slots in the seat shell and cover corre-
sponding to their shoulder height positions.
Feed the harness tabs through the side
slots making sure the straps are not
twisted. Push the elastic ties under the
cover through the side slots. Do up the
elastic ties to secure the tabs and refasten
the Velcro strips at the back.
Refitting the cover
The Traveller Plus, its cover, comfort pad,
head support and chest pads have been
carefully designed, manufactured and
tested to high safety standards.
Dont put your child's safety at risk
by using other makes of replacement
cover, comfort pad, head support or chest
pads. They could stop the Traveller Plus
protecting your child as well as it should.
Replacement covers, including head
support, chest pads and comfort pad, are
available from your Britax stockist.
Replacement cover
3
3.
Re-thread the straps through the side slots of the cover and shell so that the metal tabs are
now back in their original position under the seat. Re-secure them using the cover elastic. Pull
the harness straps forward to remove any slack. Make sure the harness straps are not twisted
and are threaded through the buckle tongues as shown.
Buckle Tongues
2
2.
Make sure the buckle tongues are the
right way round when re-threading the
harness straps and chest pads through the
shoulder slots. When facing the back of
the Traveller Plus, the largest buckle
tongue is always to the right.
1.
Make sure the harness is properly
threaded through the harness adjuster
loop as shown above.
DO NOT
thread the chest pads strap
through the harness adjuster loop.
Harness
adjuster loop
Metal tab
Chest pad
1
Britax does not recommend unthreading the harness from the harness adjuster loop.
However, if the harness does become unthreaded, follow the instructions below.
