HOW TO USE
42
TO RECLINE RESTRAINT
The child restraint may be reclined or positioned
upright without removing the child from the restraint
but it is easier without the child. To fully recline the
restraint, move recline foot by squeezing the Foot,
squeezing the recline foot handle while rotating to the
rearward facing position (refer to label on the side
of the restraint) until the handle locks into position.
Ensure recline foot locks into position. The extent of the
recline will be limited by the location of the anchorage
point. Loosening of the upper anchorage strap may be required when positioning the restraint to either
an upright or reclined position. Once the required position has been determined ensure to tighten the
upper anchorage strap and re-check the car seatbelt tension i.e., all slack to be removed.
TO REMOVE RESTRAINT FROM VEHICLE
A. Disengage the seatbelt tongue from the buckle and remove
from the restraint. Pull the sash belt downwards to pull it out
of the upper lock-off.
B. Release the stored strap and fully press upper anchorage
strap adjuster button (1) while pulling the upper anchorage
strap (2) to slacken as shown right. In some vehicles
loosening of the upper anchorage strap may be difficult. If
so, try pushing the restraint against the vehicle seat back or
slightly lifting the restraint to release the tension.
C. Disengage attachment clip from anchor fitting. The child
restraint is now disconnected.
Fully press Adjuster Button (1)
while pulling Upper Anchorage
Strap (2) to lengthen.
Storage
Band
1
2
TO REMOVE CHILD
Press the red button on harness buckle and then both harness tongues will be released. Lift the
shoulder straps from the child’s shoulders, the child can then get out.
FORW
ARD F
ACING
Recline
position
indicator
Rotate Recline
Foot to baby
position
Squeeze Recline Foot
Handle to adjust
