Instructions for Installation & Use
30
HOW TO INSTALL
SEATBEL
T
REARWARD FACING
panel flap
Centre
D. Fully lengthen seatbelt and through
the blue
REARWARD FACING
BELT PATH
opening feed the seatbelt
between the restraint cover and the
restraint body through seatbelt slots in
restraint.
Pass buckle tongue through slot here
headrest trim end
Pass buckle tongue through slot here
E. Engage seatbelt buckle and tongue.
Push down on the seat (by hand), whilst
pulling the sash belt firmly to tighten the
seatbelt. This will make the lap belt very
tight across the restraint. Whilst holding
the seatbelt tension, ensure to remove all
slack from lap part of seatbelt by pulling
sash belt. For retractor seatbelts, allow
excess belt to feed back into retractor.
NOTE: Seatbelt buckle and tongue must not
rest between restraint cover and restraint. If
seatbelt buckle is adjustable, adjust buckle as
low as possible away from the restraint.
Push down on the seat