24
25
Instructions for Installation & Use
- Series No. BS7300N-020133
Instructions for Installation & Use
- Series No. BS7300N-020133
REARWARD FACING
REARWARD FACING
NOTE: Seatbelt extenders should not be used
if the seatbelt is not long enough to secure the
child restraint. If they are used then the buckle
must not enter the seating zone.
F. Replace the centre panel flap, ensure the
harness buckle is through the panel, and
connect the hook and loop to retain the cover.
Replace the padded insert (if removed). Do not
use padded insert if the child's shoulders reach
the lower shoulder height marker or the child no
longer fits the insert. See page 30 for advice on
positioning the shoulder straps.
HOW TO INSTALL
HOW TO INSTALL
G. Fit the attachment clip to the car's anchor fitting as
shown right. Make sure to remove as many twists as
possible from the upper anchorage strap.
H. Tighten top tether strap by pulling adjustment strap
to remove slack, leave the strap slack on the side the
baby will be placed into the seat from. Any slack will
be removed once the baby has been harnessed into
the seat.
I. Remove the slack from the adjustable top tether strap
by pulling adjustment strap (3), After the baby is fitted
in to the harness, remove all slack in the top tether
strap and roll up excess strap and place in the pocket
provided.
Do not tighten the top tether strap such that the
restraint is lifted up. Remove slack only.
Attachment Clip
Car's Anchor Fitting
CAUTION:
CHILDREN CAN BE INJURED OR RESTRAINTS AND TOP
TETHER STRAP DAMAGED BY UNSECURED CARGO IN A
COLLISION. SECURE OR REMOVE HAZARDOUS CARGO
BEFORE USING THIS CHILD RESTRAINT.
Pull Adjustment Strap
to remove slack
Fully press Adjuster Button (1) while
pulling Upper Anchorage Strap (2)
to lengthen.
1
2
3
Roll up excess strap and
store in the pocket attached
to the cover.
