22
23
Instructions for Installation & Use
- Series No. BS7300N-020133
Instructions for Installation & Use
- Series No. BS7300N-020133
D
A
INSTALLING INTO A VEHICLE
WITH SEATBELT. (REARWARD
FACING)
A. Position restraint rearward facing in the chosen
seating position. The restraint align centrally
with a child restraint anchor fitting if possible.
B. Undo the buckle and place buckle tongues in
the Harness Tongue Holders on each side of
the cover.
C. Remove padded insert (if fitted), and
gently lift the centre panel flap, with the
comfort pad from the inner seat of trim.
D
Insert pad
C
blue
REARWARD FACING
BELT PATH
label
HOW TO INSTALL
HOW TO INSTALL
REARWARD FACING
REARWARD FACING
panel flap
Centre
D. Fully lengthen seatbelt and feed through
the blue
REARWARD FACING
BELT PATH
opening between the
restraint cover and the restraint body.
Pass buckle tongue through slot here
Centre panel flap and
comfort foam
E. Engage seatbelt buckle and tongue. Push down
on the seat, whilst pulling the sash belt. This will
make the lap belt very tight across the restraint.
Whilst holding the seatbelt tension, ensure to
remove all slack from lap part of seatbelt by
pulling sash belt. For retractor seatbelts, allow
excess belt to feed back into retractor.
NOTE: Seatbelt buckle and tongue must not
rest between restraint cover and restraint. If
seatbelt buckle is adjustable, adjust buckle as
low as possible away from the restraint.
Push down on the seat
Front of Vehicle
Harness Tongue
Holders (where
fitted)
Pass buckle tongue through slot here
