Versa-Tether
®
24
4
Hook the tether to an anchor point .
•
See figure A for forward-facing installation .
•
See figure B for rear-facing installation . Rear-racing
installation may also require use of the Tether Connector
Strap, as described on page 25 .
5
Pull the adjuster strap to remove all slack .
6
Verify that there is tension in the tether strap and that child
restraint is properly secured .
NOTE:
•
The rear-facing recline angle of the child restraint should not
exceed 45º from vertical .
•
The rear-facing recline angle can be adjusted by tightening the
tether as described in figure B, using anchor point 3 .
•
It may be necessary to loosen the tether and vehicle seat belt
before adjusting the recline position .
Using the Rear-Facing Tether Connector Strap
IMPORTANT:
Only use the tether connector strap (
Fig. C
) for rear-
facing tether installation . Because every vehicle model is different,
sometimes you cannot find a location to properly anchor the tether,
or the structural part of the seat is too large for the hook . Use the
tether connector strap to assist in creating an anchor point .
B
A
