Britax HIGHWAY 65, Руководство пользователя

Страница: 15 / 45

26 27
LATCH Installation
Install with the LATCH as shown above.
Before You Begin:
• Check that your vehicle has lower anchors.
* Refer to your vehicle owner’s manual or contact the vehicle
manufacturer for the maximum weight rating for their lower
anchors. Use vehicle belt (not lower connectors) for installations
with children who weigh more than the vehicle lower anchor limit.
Unless specified otherwise by the vehicle manufacturer, assume a
40 lb (18.1 kg) child is the vehicle lower anchor limit.
• Remove the lower connectors from the storage slots in the base.
Press the adjuster release button and pull the lower connector
strap to full length. Repeat for the second strap.
• Remove the Versa-Tether from the pouch and place it up and over
the child seat back.
* Britax recommends that the Versa-Tether is used at all times. Using
the tether will improve the stability of the child seat and reduce
the risk of injury. Check your vehicle owner’s manual for tether
anchor locations. Only attach the Versa-Tether to anchor points
designated to the chosen seating position as indicated by your
vehicle owner’s manual.
• Adjust this child seat to position 1 or 2 and place forward-facing
on the vehicle seat (see page 15).
* Ensure that no more than 20% or 3 in. (7.6 cm) of the base hangs
over the edge of the vehicle seat.
1
Firmly press the lower
connectors onto the adjacent
lower anchors.
• A click confirms attachment.
• Verify that the lower connector
strap is not twisted.
TIP: You may need to turn the back
of the child seat toward you for
easier access to the vehicle lower
anchors.
NOTE: If a click is not heard when
connecting either lower connector, the
lower connector strap may be twisted,
or there may be debris in the lower
connector. Correct either situation
before continuing with the installation
process.
2
Push the child seat down while
pulling each lower connector
strap to tighten.
3
Attach the Versa-Tether to
a designated anchor (see
vehicle owner’s manual) and
remove slack (see pages
17 – 19).
4
Store excess webbing in the
elastic strap.
Checklist
9
Check that all connections are secure.
9
Check that the lower connector straps are not twisted.
9
Check that no more than 20% or 3 in. (7.6 cm) of the base hangs over
the edge of the vehicle seat.
9
Check that the child seat cannot be moved front to back or side to side
more than 1 in. (2.5 cm) at the belt path. If the child seat is not secure,
repeat installation or use a different seating location.
9
Check that any excess Versa-Tether
®
webbing is contained within your
vehicle and secured in the elastic strap.
Forward-Facing Installation Forward-Facing Installation
1
2
WARNING!
• Your child seat may not perform as intended if the base of the child
seat is not flat on the vehicle seat.
• HUGS chest pads must be installed when using the child seat in a
forward-facing position.
3
4