IMPORTANT
-
The child seat
MUST
only be used with a lap and diagonal
seat belt.
The child seat has an adjustable support leg
(dia 4a)
. The smaller the child the
more reclined the seat must be. The larger the child the more upright the seat
must be.
To change the position (if required) pull the support leg clips off of either side
and slide the telescopic leg in or out
(dia 4b)
. Once satisfied with the position
of the support leg, refit the clips in the holes
(inset)
. Make sure the hole
positions chosen are the same on both sides.
Push the vehicle front seat back to accommodate the child seat ensuring that
any passenger directly behind will still be able to sit in a comfortable position.
The larger your child, the more upright the sitting position should be.
Place the child seat rearward facing and push firmly into the car seat
(dia 4c)
.
IMPORTANT
-
DO NOT
rest the back of the child seat on the dashboard or
close to the windscreen.
Extend the footprop fully and make sure that the footprop tether brackets are
facing forwards and that the straps are not twisted. Lower the footprop and
adjust the height so that it is within approximately 30mm of the floor
(dia 4c)
. Use the ruler printed on the back page of this manual to get the
correct distance from the footprop to the floor.
Slide the loop ends of the tether straps
between the front car seat and back
as shown
(dia 4d)
. Bring the buckle
ends of the tether straps around the
outside of the car seat and feed through
the loops
2
. Slide the buckle ends
under the seat. Snap the buckles of the
tether straps onto the tongues on the
sides of the child seat
3
. Provisionally
tighten the tether straps by pulling the
loose ends downwards
4
.
4a
4b
4c
4e
2
4
4. Installing your child seat (rearward facing) in front seat
IMPORTANT
- This child seat has been designed to perform safely and independently of further external restraint.
3
4d
Securay HiWay_text.indd 11
04/02/2009 09:39:12