02/15
Model 2500.CT
Page 6 of 11
STEP 9:
Remove the top cover from the unit, and then carefully pry the circular lid off of the water tank.
On the underside of the lid are two floats – the larger float is the main float that closes the
water inlet valve when the tank is filled. The smaller float is the failsafe float; it keeps the tank
from flooding if the main float malfunctions.
NOTE: If the failsafe float trips, water cannot flow through the inlet valve until the red
reset button on the top of the inlet valve is pressed.
Make sure the floats have not become dislodged and can move freely. Press the failsafe float
upward against the tank lid to trip it, but
do not
reset it at this point.
STEP 10:
Turn on the inlet water supply – the system should
not
fill, because the failsafe float
mechanism was tripped in Step 9. Press the red reset button on the inlet valve on the water
tank lid; the system should fill.
NOTE: This verifies that the failsafe float is functioning.
Check the inlet tubing and the unit for leaks. Reinstall the inner lid and replace the top lid.
STEP 11:
Make sure that the hot
water tank power switch on
the back of the cooler is in
the “Off” position.
Plug the
cooler into 115VAC wall
power using the supplied
power cord.
STEP 12:
Press the “Cold” button (see
diagram under Operation
section); the ring around the
“Water” button should turn
blue. Press and hold the
“Water” button until water
begins to dispense (if it does not emit from the nozzle after a moment, consult the
Troubleshooting section).
STEP 13:
Press the “Hot” button (see diagram under Operation section); the ring around the “Water”
button should turn red. Press and hold the “Water” button. The hot tank will fill and water will
eventually begin to dispense. Stop and restart dispensing until all air is evidently gone from
the system. Flip the hot tank power switch to “On.”
NOTE:
Turning on the hot tank power switch without first filling the tank can damage
the unit.
SIP Sanitization Setup
The cooler may be sanitized using the integral SIP (Sanitize in Place) ozone technology. This
can be done by using the default daily sanitization mode (see below) or by running the SIP
manually for a more complete cleaning (see Maintenance section).
NOTE: The system is not available for use while the SIP sanitization is running
(approximately 1 hour), so it is generally preferable to set it to run when the cooler is
least likely to be needed.
STEP 14:
Press and hold the white button on the back of the cooler (see diagram above) until it has
beeped
twice
(about 7 seconds). The light ring around the “Water” button will begin flashing
white.
STEP 15:
The SIP system is designed to activate automatically every 24 hours. Press the white button
X number of times, where X equals the number of hours
from the current time
until the
desired daily sanitization time, then press the “Water” button to save the new setting.
Example:
you are setting up the SIP sanitization and it is 2PM. You want the SIP to activate
every day at 10PM, so you press the white button 8 times, and then press the “Water” button.
NOTE:
Pressing a button other than the “Water” button or the white SIP button, or waiting 15
seconds without pressing any button, will exit from setup mode without saving.
NOTE:
Entering setup mode (as done in Step 14) and immediately pressing the “Water”
button will turn the SIP functionality off.
STEP 16:
Sanitize the exterior of the unit with Clorox
®
Anywhere
®
Hard Surface
TM
Daily Sanitizing Spray
before using.
See the Maintenance section for further instructions on the SIP user interface.
