BRISTELL BRMAERO Bristell B23, Руководство по обслуживанию

Страница: 130 / 272

Airplane Maintenance Manual Bristell
B23
Chapter 27
Chapter 27 Page 16 Issue: 30-Sep-2020
Removal
See Figure 7.
▶ Remove rudder as per Chapter 27-20-01 to get access
to the aft control cable attachment.
Access to the front control cable attachment is possible through the
front gear channel.
▶ Remove seat backrests and seats (Velcro straps).
▶ Remove middle console (Allen screws).
▶ Cut the control cable (1) in the cockpit in front of and aft
the turnbuckle (5) with Nicopress sleeves (4).
▶ Remove turnbuckle with Nicopress sleeves.
▶ Attach an auxiliary wire to the aft part of the control
cable for later installation of new cable.
▶ Disconnect the aft part of the control cable from rudder
control lever (7).
▶ Pull out aft part of the control cable rearward and thus
provisionally installing the auxiliary wire.
▶ Disconnect control cable from auxiliary wire.
▶ Disconnect the front part of the control cable from
rudder torque tube lever.
▶ Pull out the forward part of the control cable to the front.
Installation
See Figure 7.
▶ Pre-install cable thimble with Nicopress sleeve to one
end of the forward and aft part of the new control cable.
▶ Grease the new cable with lubricant grease before
installing it to the fuselage.
▶ Connect the free forward end of the aft control cable to
the provisionally installed auxiliary wire.
▶ Insert the new cable from the rudder side into the
fuselage by pulling the auxiliary wire forward.
▶ Remove the auxiliary wire.
▶ Connect the aft control cable to the rudder control lever
(7).
▶ Connect the free end of the aft cable with the turnbuckle
(5) by making a Nicopress joint (4).