5
6
2
4
3
1
Pack Contents
Installation Instructions
& User Guide
Prior to Installation
Installation
Please leave these instructions
with the end user
Product Code: VAL2 BIB C 6 CD (D1)
All products manufactured and supplied by Bristan are safe provided
they are installed, used correctly and receive regular maintenance in
accordance with these instructions.
This product has been tested to the Water Regulations Advisory
Scheme (WRAS) and satisfies the requirements of the Water Supply
(Water Fittings) Regulations 1999 and current bylaws.
For full Installation Requirements & Notes (IRN) please visit
wras.co.uk/directory.
We recommend isolation valves to be fitted to the inlet water
supplies to ensure ease of future maintenance.
Before installing these taps the water supply must be
thoroughly flushed in order to remove any swarf, solder etc.
This product must not be modified in any way as this will
invalidate the guarantee.
If power tools are used do not forget to:
- Wear eye protection
- Unplug equipment after use
If in doubt, contact a registered plumber or your Local Water
Authority or the Secretary of the Institute of Plumbing, address
as follows:-
The Institute of Plumbing,
64 Station Lane,
Hornchurch,
Essex,
RM12 6NB, Tel: 01708 472791
Feed the tap bodies
through the wall.
Screw the shrouds on
to the tap bodies.
Secure the taps by using washers and metal
backnuts behind the wall (not supplied).
Connect the hot and cold water
supplies to the threaded tails.
We recommend using elbows
(not supplied).
Turn on water supply.
REMEMBER
Hot on the left,
cold on the
right!
To replace any spare parts
for your tap, why not
scan the QR Code or
visit
www.bristan.com
and search for your product.
Spare Parts
x2
x2
1.0
5.0
Pressure
BAR
0.2
4.0
2.0 3.0
Pressure
BAR
1.0
5.0
0.2
4.0
2.0
3.0
Specifications
Maximum Static Pressure: 10.0 bar
Inlet Water Temperature
Inlet Connections
Min: 0.2 bar
Max: 5.0 bar
Dynamic Water Pressure
Tools You’ll Need
Flat Head
Screwdriver
Long-Nosed
Pliers
1/2” BSP
60
°
C
65
°
C
60-65
°
C Recommended
Identify the required position of the taps and
prepare the water supply pipes.
Mark and drill holes. Finish the wall surface.
Create the rear
access point
in the back of
the wall cavity.
IMPORTANT
Turn on w
ater
supply f
or a few
minutes and check
all joints and
connections f
or
any leak
s.
IMPORTAN
T
Bib taps can a
lso
be fitted to X U
S C
and BTE C
.
Please refer t
o
those instru
ctions
if being used
.
Crosshead
Screwdriver
Adjustable
Spanner
Pipe Cutter
Pencil
Safety
Goggles
Drill
