Introduction
Thank you for choosing Bristan, the UK’s leading taps and showers expert. We have designed this product with
your enjoyment in mind. To ensure that it works to its full potential, it needs to be fitted correctly. These fitting
instructions have been created to give you all of the information you need and, if you need any further help, please
do not hesitate to give us a call on 0844 701 6273.
Safety Note
Please read these instruction thoroughly and retain for future use.
All product manufactured and supplied by Bristan are safe provided they are installed correctly, used correctly and
receive regular maintenance in accordance with these instructions.
These fittings need to be installed in accordance with and meet the requirements of the Water Supply (Water
Fittings) Regulations 1999 and Scottish Byelaws 2004.
Specification
This product is suitable for use at all supply pressures. If installed at low pressure (tank fed), then the minimum
distance from the outlet of the nozzle to the underside of the cold tank should be approximately 2 metres to ensure
adequate performance.
Min.
Max.
Operating pressure range (bar)
Maximum static pressure – 10.0 bar
0.2
5.0
NOTE:- Nominally equal (balanced) inlet supply pressures are recommended for optimum performance.
Installation
1.
Identify all components and check for completeness, particularly before arranging fitting.
2.
Install the taps (1) onto the basin/bath or sink. The backnut (3) and backnut washer (2) are used to secure
the tap to the surfaces of basin/bath/sink.
3.
Connect the hot and cold water supplies.
4.
Turn on both water supplies, open both taps letting the water run for a few minutes to check all joints and
connections for leaks.