8
7
9
10
12
11
13
2
3
4
6
5
1
d
e
f
c
15
b
a
14
WATER PRESSURE
This mixer is suitable for use at all supply pressures. However for optimum use both
the hot and cold supplies should be reasonably balanced.
If the fitting is installed at low pressure (tank fed), then the minimum distance from the
outlet of the nozzle to the underside of the cold tank should be 2.0 metres to ensure
adequate shower performance.
This mixer should be installed in compliance with the Water Regulations. Where the
supplies are unbalanced, i.e hot water from the cylinder tank/cold from the mains,
approved check valves must be fitted in the supply pipes. For further details contact
your Local Water Authority.
PLEASE NOTE:
0844 701 6273
In the unlikely event you find a part missing, please contact our Customer Service
helpline on
for immediate dispatch of part
INSTALLATION
1. Identify all components and check for completeness, particularly before
commencing installation.
2. Fit the mixer body (1) to the bidet using the ‘C’ plate fixing kit. The plinth (3)
and O-ring (15) go between the fitting and the bidet, and the ‘C’ shaped
rubber (4) and metal washers (5) on the underside of the bidet. Secure
Into position using the threaded rods (8) and nuts (6).
3. Fit the tail pipes (7) to the fitting and connect the hot and cold supplies.
4. Fit the pop-up waste, using washers (11) below & (12) above the bidet
& connect it to the mixer. It is recommended that a silicon sealant be applied to
both sealing faces of washers (11 and 12). The waste can be set by adjusting the
waste rod (9)/ operating rod (2) connecting bracket and the screw in the base of
the plug (14).
5. Fully open the mixer in the mid position, letting the water flow for a few minutes
to check all joints and connections for leaks.
6. See back page for aftercare instructions.
N.B. Please write the name and product code of your fitting in the spaces
provided overleaf. This will ensure a speedier service if you should need to
phone the helpline.
MAINTENANCE
If the fitting begins to drip:
Note: That there are locating pins on the bottom of the cartridge that fit in
Holes inside the tap, to ensure it is fitted the right way round.
1. Turn off the water supply
2. Remove indice cap(a), loosen grub screw (b) with 2.5mm hexagonal key and
pull off head (c), unscrew shroud (d) retaining nut (e).
3. Remove cartridge (f).
4. Clean or replace cartridge, clean and grease seal and refit.
5. Replace cartridge and head, then turn on the water supply.
6. Contact our helpline if problem persists.
CONTENTS
1. Mixer Body
2. Pop-up Operating Rod
3. Plinth
4. C-shaped Rubber Washer
5. C-shaped Metal Washer
6. Nut
(x2)
7. Copper Tail Pipes
(x2)
8. Threaded Rod
(x2)
9. Waste Rod
10. Waste Body
11. Washer
12. Washer
13. Waste Flange
14. Plug
