BriskHeat
®
Corporation. All rights reserved
7
SRL-ADJ & SRP-ADJ Silicone Rubber
Heating Blankets
ADJUSTMENT OF TEMPERATURE SET-POINT
Turn dial to desired setting. Heaters designed for metal surfaces (SRL-ADJ
series) can be adjusted 50-425°F (10-218°C). Heaters designed for poly
surfaces (SRP-ADJ) can be adjusted 50-160°F (10-71°C).
NOTE: If precise temperature control is required
for your application, please contact BriskHeat or
your local distributor for application assistance
and product solutions.
TROUBLESHOOTING GUIDE
Please read this guide prior to contacting BriskHeat
®
. This guide is designed
to answer the most commonly asked questions. If you are unable to identify
the problem or need additional assistance, please contact us at
1-800-848-7673 (U.S. / Canada)
,
1-614-294-3376 (worldwide)
, or
.
PROBLEM
SOLUTION(S)
Heater does not warm up
Verify heater is connected to proper voltage.
Check to see if there is a resistance reading (not an open
circuit) in heater using an ohm meter.
Pressure sensitive
adhesive is not adhering
Verify date of manufacture. PSA has a shelf life of 6 months.
Ensure there are no air gaps and heater is making
intimate contact with surface being heated.
Confirm:
Medium to hard rubber roller used for install.
Surface properly cleaned and clear from oil, dirt and
residue.
Installation occurred above 40ºF (4ºC)
Circuit breaker is tripping
Validate that the circuit breaker is capable of handling the amp
requirement of heater. The identification label located on the
power cord displays the heater’s amperage requirement.
Examine heater and cord for any damage.
Check to see if there is a resistance reading between power
leads and the ground lead.
BriskHeat
®
Corporation. All rights reserved
8
SRL-ADJ & SRP-ADJ Silicone Rubber
Heating Blankets
1055 Gibbard Ave, Columbus, OH 43201
Toll Free: 800-848-7673
Phone: 614-294-3376
Fax: 614-294-3807
Email: [email protected]
PN: 11661-06 Rev B
WARRANTY INFORMATION
BriskHeat
®
warrants to the original purchaser of this product for the period of
eighteen (18) months from date of shipment or twelve (12) months from date of
installation, whichever comes first. BriskHeat
®
’s obligation and the exclusive
remedy under this warranty shall be limited to the repair or replacement, at
BriskHeat
®
’s option, of any parts of the product which may prove defective
under prescribed use and service following BriskHeat
®
’s examination, is
determined by BriskHeat
®
to be defective. The complete details of the warranty
can be found online at www.briskheat.com/t-warranty.aspx or by contacting us
at 1-800-848-7673 (toll free, U.S. / Canada) or 1-614-294-3376 (Worldwide).
