11
5.
Complete the Installation
A.
Connect the shut-off valve tube (J) to the inlet water
connection (1).
B.
Connect the RO water tube (K) to the RO water connection (2).
C.
Connect the filtered water tube (K) to the filtered water
connection (3).
D.
Connect the RO waste water tube (I) to the waste water
connection (4).
E.
Ensure all connections are secure before proceeding.
Operation
Start Up the Filtration System
1.
Ensure all water connections are completed as described in the Installation section.
2.
Turn the cold water supply on. Open the shut-off valve on tube (J). Connect the power supply to the
filtration system and then to an outlet. The filter indicator panel turns on.
NOTE:
When the system is first turned on it goes into automatic flushing state, which lasts approximately 90
seconds.
3.
Open the RO lever on the smart faucet and allow RO water to run for 5-6 minutes, or until water runs clear.
Do not drink this water. While system is flushing, make sure there are no leaks in the joints, fittings, valves
and tubing connections.
Start Water Purification
Open the faucet and the water filtration system starts to produce water.
NOTE:
If the faucet runs water for a long time (for 2 hours), the filtration unit enters overtime protection
mode. The display screen flashes, and the system is no longer able to produce water. Unplug the
filtration unit, then plug it in again to clear the protection mode.
Shut Down
1.
Close the shut-off valve on the tube (J).
2.
Unplug the power supply.
7
2
1
3
4
J
I
K
