5
Darker
Lighter
Single flash every 30 seconds
–
Door is open
Double flash every 30 seconds
–
Door is closed
Single flash every 10 seconds
–
Door is open, replace batteries soon!
Double flash every 10 seconds
–
Door is closed, replace batteries soon!
Single flash every second
–
Door is stuck or batteries too discharged to
open the door. Investigate cause!
Cleaning:
Disconnect the battery holder before cleaning the ChickSafe Eco.
Keep the battery holder and electrical connections dry at all times.
Do not immerse the ChickSafe Eco in water.
Wipe surfaces clean with a damp cloth and mild detergent as necessary.
Reset:
If the batteries have been connected before the door is installed, or if the cord has become detached from the door,
it may be necessary to reset the system:
1. The ChickSafe must be upright in its installed position.
2. Disconnect the battery holder connector.
3. Wait 1 minute.
4. Gently pull the end of the cord down and, while pulling, refit the battery holder connector.
5. Maintain tension on the cord. After 10 seconds the cord will be wound out for a second and then start to wind in.
6. Keep maintaining tension on the cord all the time until the motor stops.
7. Disconnect the battery holder.
The system is now reset to the factory position. Follow the installation instructions from the start to ensure the door
opens to the correct position. For helpful information see our ChickSafe
‘
Frequently Asked Questions
’
page at
www.brinsea.com
Closing Light Level Adjustment
Closing light levels at dusk vary with location and direction of
installation. The light level that makes the door close may be
adjusted:
360 degree turn clockwise to decrease light level (darker).
360 degree turn anti-clockwise to increase light level (lighter).
(Use a small, flat precision-screwdriver).
Adjust by one turn at a time. The adjustment range from the
factory setting is approximately 5 turns darker (clockwise), 15 turns
lighter (anti-clockwise). Adjusting further than this range has no
effect.