Brinkmann 810-3420-A, Руководство пользователя

Страница: 11 / 32

10
MATCH LIGHTING THE MAIN BURNERS:
1. Open lid before lighting.
2. Make sure all control knobs are in the “
” (OFF) position.
3. Place a paper match in the end of the matchlighter. Strike the match
and place through lighting hole in the left hand side of the grill to
approximately 1 to 2 centimeters from the burner.
4. Turn on the FAR LEFT burner control knob to the “ ” (HIGH) position.
The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to “ ” (OFF) and wait
5 minutes for gas to dissipate and repeat lighting procedure.
6. Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the “ ”
position.
7. If the burner does not light within the first few attempts of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected.
Note: If burner does not light or flame is too low, See “Troubleshooting” section of the owners
manual.
LIGHTING THE SIDE BURNER:
1. Open lid before lighting sear burner.
2. Make sure control knob is in the
“ ” (OFF) position.
3. Push and turn the control knob to the “ ” (HIGH) position. Continue to
push in control knob while pressing electronic igniter for 3–5 seconds.
4. If ignition does NOT occur in 5 seconds, turn control knob to “ ” (OFF) ,
wait 5 minutes to allow gas to dissipate and repeat lighting procedure.
5. If burner does not ignite using the igniter, see “Match Lighting the Side
Burner” section.
6. To turn off, turn control knob clockwise until it locks in “ ” (OFF) position.
Note: If burner does not light or fl ame is too low, See “Troubleshooting” section of the owners manual.
MATCH LIGHTING THE SIDE BURNER:
1. Open lid before lighting sear burner.
2. Make sure control knob is in the
“ ” (OFF) position.
3. Strike and carefully place a match approximately 1 to 2 cm from the burner.
4. Push and turn the sear burner control knob to the
“ ” (HIGH) position. Continue to push in control
knob while holding a match to burner. The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to “ ” (OFF) and wait 5 minutes for gas to dissipate
and repeat lighting procedure.
6. If the burner does not light within the fi rst few attempts of match lighting,
there is a problem with the gas supply. Turn off the gas at the burner and
cylinder. DO NOT attempt to operate the sear burner until the problem is
found and corrected.
Note: If burner does not light or fl ame is too low, See “Troubleshooting”
section of the owners manual.
Note: Observe flame height when lit: Flame should be a Blue/Yellow color
between 3 to 5 centimeters when burner is on “ ” (HIGH).
See section in manual on burner adjustment to adjust flame.
Lighting Hole
Matchlighter
5
cm
3
cm
0
cm